Need help wiring 3pdt and in/out jacks to this TS808 vero

[FuzzyLotus]

Hello all!
I'm trying to make sense of this schematic, I've only been building pcbs until now, I figured I'd try my hand on a vero board build, however, I have no clue how I'm supposed to wire the 3pdt switch and input + output jacks and LED .. Anyone can help me please figuring out this?

Any drawings or diagrams would be superbly helpful, as I'm a visual learner!

Thanks!!



Build was found here:

Ibanez TS808

Collection of vero (stripboard) & tagboard layouts for 100s of popular guitar effects, with over 1000 verified designs. DIY your own boutique effects!

tagboardeffects.blogspot.com

Much love!

-D

 

[VanWhy]

This is a pic I grabbed from someone in this forum. This was super helpful to me when i started doing stripboard builds.

 

[Ginsly]

You can get some handy 3pdt pcbs with all necessary connections (other than pots and switches). They make stripboard MUCH easier for me. These specific ones seem to be unavailable, but look on Love My Switches, they have a great one.

 

[FuzzyLotus]

Thank you all for your help, that greatly helped me, however, I think I may have wired my pots in reverse? Would that make my level pot act in reverse (If I turn clockwise, volume goes down, if I turn counter clockwise, volume goes up) ?
Cheers!

 

[VanWhy]

Thank you all for your help, that greatly helped me, however, I think I may have wired my pots in reverse? Would that make my level pot act in reverse (If I turn clockwise, volume goes down, if I turn counter clockwise, volume goes up) ?
Cheers!

Most likely. I have done that before with stripboard layouts. This is another great resource: https://wiki.pedalpcb.com/wiki/Potentiometers

 

[FuzzyLotus]

Most likely. I have done that before with stripboard layouts. This is another great resource: https://wiki.pedalpcb.com/wiki/Potentiometers

Yup, analyzed the circuit and indeed the pots were inverted hehe!
Thank you again for your valuable help!

Rock on!