Omitting chargepump from Delegate Boneyard

[zeropluszero]

Hey guys, simple question, I'm pretty new and don't have any experience reading schematics, so a pedalpcb build that's basically solder by numbers works great.
I have a spare 18v port on my power supply I'd like to use for the delegate boneyard if I could omit the chargepump... would I need to remove or replace any other components? As best I can tell it's connected between d100, 101, 102 5817's...do I need to take some of these out?

Thanks!

 

[tcpoint]

Omit IC2, D101, D102, C101 and C102. Put a jumper from pin 1, IC2 to the cathode of D102.

Look at the schematic and that should make sense.

 

[jwin615]

Looks like there's already a bypass on the board. Can probably just jumper d101 and d102 and omit c101 and c102
I'd prob jumper IC2 pin 2 to pin 3 so you don't have a floating traceas well

 

[zeropluszero]

Both replies sort of make sense when I look at the schematic...

 

[tcpoint]

Jwin615's solution is easier two little jumpers.

 

[zeropluszero]

I've actually already soldered 99% of it together before having this epiphany...was just waiting for a single capacitor I missed, so it'll actually be me desoldering 4 parts and doing the jumper haha.
Thanks for the replies.