Big Monk
Well-known member
I bet most people are just using the universal type inductor footprint for this but I figured I'd see if anyone is over-engineering this like I am.
Here is my current rough draft footprint:
I used some partial measurements I found on my workbench and these photos so set it up:
My goal is for the inductor to sit "squared up" on the board, rather that cockeyed like on a universal footprint.
Anyone have a verified footprint for this one?
Here is my current rough draft footprint:
I used some partial measurements I found on my workbench and these photos so set it up:
My goal is for the inductor to sit "squared up" on the board, rather that cockeyed like on a universal footprint.
Anyone have a verified footprint for this one?