Wiring Stomp LED - Mahayana Drive (Zendrive)

Jumper the LED pads on the PCB. SW on PCB to anode. Cathode to SW on breakout board.
OR
Run wires from LED pads onPCB to the LED on the switch. Wire In/Gnd/SW/Out like normal.
 
Thanks! Would your first solution still work if I wanted to keep the other LED as well? (and not jumper it of course)
 
It would work but the LEDs would get dimmer with two in a series circuit. If that doesn't bother don't change anything, otherwise reduce the value of the resistor in series with the LEDs.
 
Wasn't Mr PCB thinking of designing a board specifically for these switches? It would make life easier for anyone wanting to use these switches with a board. I prefer to wire them the old fashioned way - I honestly don't see the point of the board for the switch, but that's just me!
 
Back
Top