DailyDovetails
Well-known member
I am curious about a few capacitor exchanges and the reasons for doing or not doing them and wanted to get some opinions. For a 1u capacitor like C13(Non-polarized) in the kewpie fuzz https://docs.pedalpcb.com/project/KewpieFuzz-PedalPCB.pdf or C11 in the Pestle distortion https://docs.pedalpcb.com/project/PestleDistortion-PedalPCB.pdf is there any reason to use an electrolytic capacitor over say a polyester film or even a MLCC? Then say in the Pestle on C4 is there any reason to use an electrolytic over a MLCC rated for 10u? I get the use of electrolytics for power filtering and in sizes above 10u but I'm wondering if when I run across these in a circuit if there is ever a reason to use an electrolytic outside the power section.
Does it make a difference if the electrolytic goes to positive or ground like C10 in the Kliche mini SE? https://docs.pedalpcb.com/project/KlicheMiniSE-PedalPCB.pdf
Let me know what your thoughts are on this.
Does it make a difference if the electrolytic goes to positive or ground like C10 in the Kliche mini SE? https://docs.pedalpcb.com/project/KlicheMiniSE-PedalPCB.pdf
Let me know what your thoughts are on this.