T-Go

Yeah. My printer has a “HQ 1200DPI” setting that I use.

Glad to hear that worked for you. I know that going to FedEx Office and getting the printer settings straight to achieve optimum results...

i tried the GW-1 Pro on a powder coated enclosure from LMS. applied glue directly to the decal rather than the surface of the enclosure...

I keep meaning to post pics, but: I've since done two more enclosures where, before applying the actual decal, I first applied about...

Cool artwork! The graphics transfer part of the pedal building process is definitely the most frustrating part for me. Lots of trial and...

The Dishwasher Safe Mod Podge trial and error continues. I have one (mostly) success and one utter failure. First, the failure...

1. I do squeegee the decal quite a bit, but I try not to overdo it. I repeatedly dip the squeegee in water to help with the flow. Also...

I have a heat gun too and it is way too hot for this. It would melt the plastic transfer sheet and probably damage the powder coating if...

I used to use a hair dryer back when I first started doing this (with the W1+ glue). I switched to the toaster oven just because it's...

I do believe there may be something to the hair dryer treatment. The hot air is very direct on the transfer sheet. I can't actually see...

Hmm, that's interesting. It doesn't sound radically different than what I did. You used a hair dryer, where I used a toaster oven, but...

Thanks! I haven't tried transferring to bare aluminum, only Tayda powder coated enclosures. It's important to first prep the enclosure...

This is a variation on the 555-based Relay Bypass Board sold here. This circuit drives a 5V relay, or any other coil voltage up to 9V...

Great job on tidying up that foot switch wiring!

Went and rewired everything, we have Chorus now! Oddly the LED's are still not lighting, even though I verified A & K on the right...