D.M.N.

I’d start with 1M and work from there on a breadboard.

Haha, probably. Okay, that's pretty much how I was planning to use it. Is the value of the resistor not critical then?

You may be overthinking it. If it were up to me I’d add a coupling cap for whatever section you want to put before it (dirt of some...

Hi all, I'm very fond of my DOD FX10, and especially the tone control in it. I want to add the tone control to other circuits I'm...

'Ludes were developed to replace barbiturates because 'barbs were so addictive. The irony was that 'Ludes turned out to be as addictive...

On the 200s adaptation, it was labelled as mids, but the 200s doesn't have a mids knob, and on the 2000s it's called Contour, which is a...

Here's a schematic that someone else created a few years back. I've built it on perfboard and it sounds fab! Edit - notice you already...

Ah, good catch, completely forgot to update those when I decided to run it at 18v instead of 9v. I wasn't sure how much drive that...

Perfect! Thank you, that's what I thought, seemed odd that the 200s had the pots scaled but not the component values. The pot values in...

If you scale down tone stack resistors/potentiometers 10x than you have to scale up capacitor values the same amount. So - R7 not 56k...

My #1 amp for...jeez, 15 years? has been a Sunn 2000s. Absolutely love the things, still have 2 that trade duties. I saw a schem and...

Ordered 5 prototypes today, shipping was back down to $8. TACO!

It is very telling that even with 175% Tariffs, JLCPCB was never in any danger of me leaving.

A month or so ago I was playing with my own Slap-Back delay ideas, some based on a VFE delay; re-jiggered some things on Electric...