Bambalam

I highly recommend two detailed tutorials from Phil's Lab on PCB design in Kicad9. They're quite long, but the amount of practical...

I started the course based on your recommendation. It’s exactly what I was looking for. I had some questions in one lesson and again...

Hey everyone, I made the Pedal Division PCB course, I'm glad to see it's been a saving grace for those who felt they didn't get the...

I'm working on a pedal idea and I'm not sure if the controls are possible. It's a drive pedal with an effect that can be blended into...

I don't see any EL34/6CA7 or EF86/6267 tubes in my collection. Ates doesn't sound familiar. I certainly have not seen that box before.

I’ll see if I have any of those. Pretty sure I do

I made this tube spreadsheet and note what each tube was used for. I don't keep any TV only tubes, just radio, amp and some tubes used...

Very cool! Those are 807s I guess? I built a single ended amp with them, still got a few spares from back in the day, similar age I...

They absolutely do!

I repair tube amps and radios so I'm always on the lookout to add to the stash. Inside one radio I was working on I found 2 tubes that...

Here's the PCB version. I'm rather new to tracing circuits and drawing schematics so that's what I've been practicing. I haven't worked...

The tag board version has a lock washer lug on the switch that is used as a solder point. I'm still figuring out the off board...

Looking at the tagboard version - I'm seeing a regular looking MKI / Zonk type circuit with nothing out of the ordinary. The input...

Resistors differ on each transistor cap. Trace: Q1 cap resistor, Q2 cap no resistor and Q3 cap no resistor. Sola and Hornby: Q1 cap no...

For anyone else that might find themselves here looking for where to start, I made this and have had very positive feedback...