You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
With the stock values on the clean path, virtually nothing is being filtered. Adding more bass signal to the comp path would most likely...
-
You're right definitely looks like DC offset. What I can't figure out is why? The signal generator has no settings for dc offset, why...
-
Higher resistance means more heat and thermal noise, but also higher impedance and lower current. Impedance will be roughly equal to the...
-
@Robert finally joined “Team Both” 🤣
https://forum.pedalpcb.com/threads/refdes-vs-val.19588/
-
Do you mean the whole bootstrapped follower thing? I have never seen it in any pedal design, personally. There is an old thread on DIYSB...
-
A B1k pot with a 180 ohm resistor from pin 2 to ground will give you approximately a 152 ohm pot with a "C" taper. Wire this in series...
-
Loading…
-
Loading…
Like.
With the stock values on the clean path, virtually nothing is being filtered. Adding more bass signal to the comp path would most likely...