icziko

Thx temol. Wow, KRA is not that bad, 1.5 hr drive from RZE ;) Anyway I will try DN100. On forum I have found out that Revv G8 is...

I also don't know what to expect from this circuit, but since it's a noise gate I would expect default operation.. :) There are also...

Thx temol, I am thinking about building THAT4301 noise gate as per THAT. I have breadboard so it might take an evening to check that...

He neequo, Same as you I'm from Poland and have exactly same problems with build as you have. I have kit from Musikding + I've build my...

Musikding sent me two new THAT4301 retrofit, before got it works fine. I'm not sure how, but I guess I got two failed chip. Then I...

Hi Elijah-Baley - I have exact same issue with both board PCB and veroboard. It seems that, as you wrote, THAT4301 retrofit does not...

I have same issue as sshort86. At low Threshold setting the Gate does not fully gate and there is some noise coming from setup (EVH5150...

Normally if threshold is usable only in first half of travel the solution would be: Replace B25K pot to B10K but between B10K(pin3) and...