Blooze

Went back and messed with a bit more today. Going back to the original R6 of 91k and dropping R7 to 1.2K without any other changes gives...

Thanks for the suggestions. No luck. Tone went to hell with no adjustment and it raised the overall level by 1dB on the meter. I tried...

I breadboarded this fuzz last night and ran through the usual suspects of Si transistors ending up with 2N2222 hFe~180. It's a great...

Just had my first order come in since the tariffs. No enclosures just resistors and other small parts. $125 order cost me another $40 in...

Where are you getting them?

I think this is probably the way to go. I should have bought 3-400 of the ones I have instead of 100. They were way cheaper than tants.

You could use tants when you need a small 1µF cap.

Unfortunately, the 1µF SMD electrolytic caps are too small.

Mine are Nichicons.

They are 3x5mm nichicons. Those 4x5 are the smallest I’ve seen so far besides the ones I have.

Here I have one circled on a Madbean Glitchee. The very bottom cap on the board is a 1uF/160v which I believe is 5x11mm (that’s the only...

That’s what I’m seeing everywhere is 4x7mm. These I have are 3x5mm and fit where the normal ones I find won’t...

Anyone know where you might be able to get these tiny 1uF/50V caps anymore? I’m running to the end of my supply and they sure are nice...

Finally got around to this VFE Darkhorse via Madbean. Went with his suggestion on using a reverse 4001 on the asymmetrical clipping. You...