Recent content by _aj666

I didn't think these boards were still made anymore. I never see them posted. Would love to make one though.

Also, I understand what you're talking about. Any way I could get a visual. Maybe just draw some squiggly lines on the picture I provided. I'm going to go down and mess with it shortly. Thanks again!

Damn, so this things worked all along then. 😅 Yeah I might run a wire from those to just to have it as a standalone buffer when I'm messing with stuff. Thank you so much!

Ok so last dumb question, since all buffers work and there are no issues when they are plugged in this way. Do I need to have everything plugged in to use this interface? I can't simply just plug in my guitar to guitar, and front of amp to amp and have it work? Everything needs to be plugged in...

Lower buffer works, but there's a slight hum. Middle buffer works also with a slight hum. Top buffer works with slight hum. So everything is working correctly, just with a little hum coming through my 5150 2 on the clean channel.

Dumb question, but what's the easiest way to do this without removing it all? I don't have anything to test on a breadboard. Built a lot of pedals, but I guess I've been pretty lucky with everything working with no issues off the bat.

I'll give this a try, so basically make one continuous ground from all the green wires, will those go to the ground of the 9v power as well?

Not sure, the one is grounded. But the other 7 aren't. What would be the easiest way to ground these to the enclosure?

Yes I have them all connected as they should be, everything's soldered up and under the electrical tape. Took a shot of under the buffers as well for you.

These are the ones they've linked on the build. These are the ones I used.

Hey everyone, recently got some simple jfet buffers to get my junction box finished so I can finally wire up my board. I've been following the one that vertex pedals made, but with the pedalpcb buffers. I got it all wired up, and no signal passes and I just get a static feedback. Pretty sure...

Just curious to know if you got this going? Been wanting to build something exactly like this with the same stuff you used. Just didn't need the extra 9 volt out.

No led?! Madman

Right on, was just curious to see what orientation you had it on. I still haven't gotten mine yet so I was wondering how much space there was.

What orientation do you have your voltage regulator in? Can you post a picture?