Recent content by AaronW

Just checking again to see if anyone with a V2 Superbolt has been able to measure the voltages on the trimpots?

Someone in the JHS group on Facebook has a new Superbolt V2 on the way, they were going to post them as well. We'll be able to compare them if you or someone else has the numbers too.

I posted these on TGP, but these are the readings on my TacoBolt: TP1: 7.52V TP2: 9.73V TP3: 0.80V And Tone Ranger Audio posted these from his: TP1: 7.34V TP2: 9.72V TP3: 0.66V Will be buying the Taqueria when it's available! I was actually bugging JHS about modding a Superbolt 2 for me with...

Thanks for your help. I’ve been swamped and unable to look at it again, getting ready to visit family tomorrow. Plus I’m waiting for a new iron to arrive. I touched up a couple joints, that on further inspection may have been bad. And after that I’m getting no power to the IC. So I’m putting...

I replaced it yesterday and it’s still at 0v. So I’m going to build an audio probe this afternoon and go through it and see where its. I’m using new solder on these last two builds, I’m wondering if it has to do with that, and my 20 year old soldering iron is acting up too. I just thought it...

Yes, there is continuity on the areas you circled. I’m going to reflow the solder this afternoon. If anyone has any other suggestions let me know. Maybe I’ll try replacing the transistor too.

1 - 4.74 2 - 4.74 3 - 2.36 4 - 0 5 - 4.45 6 - 4.65 7 - 4.49 8 - 9.06 2N5457 - G - 7.4 S - 0.8 D - 0

I’ve had them for years.

No, yellow isn’t touching middle lug. Was going to reflow just to check again.

Just finished 2 pedals and both are not producing any sound. Super frustrating to say the least. I just finished troubleshooting as best I could the Glory Hole, and am at a loss of what is wrong or what to look for. Any suggestions? It powers up, LED comes on, passes sound when bypassed then...

How long do these usually take to get in? Would love this one as well. Is there a build doc for it around still?

Did you ever try a C1k pot instead of the B10k pot? I just build this and came to post the same issue as you're having. When the gain is on it's great, it'd be nice to be able to dial in different shades of it though.

Has anyone used the Little Green Scream Machine board here to build a CJOD or Landgraff Dynamic Overdrive. Kick myself for never buying the real things when I had the chance. If I could use the pedalpcb TS boards that’d save me time building boards. Thought this may work since both are just...

Transistors are soldered. I’ve double checked values. There are no solder joints touching. I’ll measure the charge pump IC pins next.

Above are the photos, just checked all solder joints, part values and locations. Really at a loss as to what it could be? Is there a way to test if the chip is bad? Or is it most likely somewhere else in the circuit?