Aentons's latest activity

I thought it was Tah dah, like you just did a magic trick. 😁

Sorry, you are right. Solid state amps tend to use tanks with a higher input impedance. I don't see it specified in the schematic but...

You can just disconnect the cable from the tank input and test the tip and sleeve of the cable.

I think the 4bb3c1b is the wrong tank for it. I think it is supposed to be a 4Ab3c1b. It has a different input impedance...

The schematic has a test point TP13 with voltages for the input to the reverb pan. If you have a multimeter, that would be a good...

I did the same and ended up getting a couple of these in the suggested hfe 51-60 range. I have not tried them yet so fingers crossed...

I remembered I have an old short reverb tank and it will fit very nicely in the bottom of the enclosure. Anybody know of a small reverb...

I'd also change the 4558 opamp to an LM1458, those little buggers overdrive in a much nicer way :)

It is actually closer to the first version of the Lead 12 (minus diodes). Marshall did several revisions of those circuits and I get the...

So it turns out that there is a jumper in the path from VR2 to C20. I'll just snip it and use the ends to install the effects loop...

Cool, thanks for the input. I'll probably add a full send and return buffered effects loop to it. Why change the cutoff freq? Also, the...

This sounds like a really fun project. The TDA2030 is pretty decent, but you don't want to make it clip. Here's what I'd do: 1...

Awesome. I didn't realize that. I looked up the 3005 schematic and the preamp is very close to it with mostly the same values. R10 and...

Team fold and solder. Quit putting the wrong parts in the holes and you’ll be fine! 🤣

A quirk that I'd like to fix is that you can't make it just clean. When you turn the tube crunch knob all the way down, it is silent...