Alan W's latest activity

Of chorus they're sharp! So, you clocked yourself a gooder. Might even say, you over-clocked it. Do tell... Just how...

There’s a documentary everyone should learn from….it’s called “Don’t Fuck With Cats” Feral or not. 😂

I'm not white-trash, just ... slight-trash.

wait someone trashed Neil? Leave this place and never come back, whoever that was. A SIMPLE ANSWER.

Well, apart from spoon-feeding you the refdes, nobody has addressed your question yet: "how does one find a specific part on the board...

I'll do a full build thread here in the next few days, but I only got this thing running properly yesterday and need to do a bunch of...

Weird! Alcohol really shouldn’t have any effect on powder coating. Makes me think it wasn’t properly baked, or that their powder was a...

Got a chance to measure the saddle. It looks like all the measurements are the same, except for the height, which is only 0.160. Thank...

I carved a ramp in the body's through hole so that they could meet up with the bridge plate holes. I have to put a little kink in the...

Are the holes (in the bridge plate) for the main (through body) strings large enough to allow you to deal with the offset? Otherwise I...

No, from my memory the saddle holes and the bridge plate holes will not line up if you switch the entire “upper” assemblies; the bridge...

I added a shim idea after you had replied… Looking at your photos, I don’t see an issue. I took off an octave part and measured it, to...

Now I wish I had taken some photos of that Amazon bridge… the Gotoh octaves are the correct height, but I’m not sure if the screw...

BEAVER: Gee willikers Wally! Nobody's mentioned the BONEYARD yet? WALLY: Good call Beav! Read through Chuck D. Bones circuit...

Are you doing any breadboarding? That helped connect (some of) the dots for me.