Alan W

OK. After a few too many work-for-salary evenings, I assembled my MicroXLR. Easily the worst solder job I've done in decades :p. Now I...

a drop of gel or liquid flux on the joints and then 2-3 seconds of reflow would probably make most of them look alright. still good...

A few years ago I came across these very handy graphics for the 1590 series boxes: There are a some boxes in the 1550 series (I...

Really enjoyed building this one! Everything went together smoothly and it sounds great! Wish the rate was maybe a touch slower but...

If you want to slow the rate down, it is as simple as increasing c3. Solder a 22-47nf capacitor onto the other side of c3 and it will...

Of chorus they're sharp! So, you clocked yourself a gooder. Might even say, you over-clocked it. Do tell... Just how...

There’s a documentary everyone should learn from….it’s called “Don’t Fuck With Cats” Feral or not. 😂

I'm not white-trash, just ... slight-trash.

wait someone trashed Neil? Leave this place and never come back, whoever that was. A SIMPLE ANSWER.

Well, apart from spoon-feeding you the refdes, nobody has addressed your question yet: "how does one find a specific part on the board...

I'll do a full build thread here in the next few days, but I only got this thing running properly yesterday and need to do a bunch of...

Weird! Alcohol really shouldn’t have any effect on powder coating. Makes me think it wasn’t properly baked, or that their powder was a...

Got a chance to measure the saddle. It looks like all the measurements are the same, except for the height, which is only 0.160. Thank...

I carved a ramp in the body's through hole so that they could meet up with the bridge plate holes. I have to put a little kink in the...

Are the holes (in the bridge plate) for the main (through body) strings large enough to allow you to deal with the offset? Otherwise I...