Recent content by blackhatboojum

I know right!? Some mojo parts. I found them at my local electronics store for a $1

“Holy crap! Another build report from Mr Black Hat?” I know. Crazy right!? Well, once again, this is courtesy of @Guardians of the analog . He sent me this pcb along with the OD-1 I posted about previously. And when a homie sends you stuff, you’re obligated to build it. The CH-1 is a...

So, my buddy Chris hooked me up with another @szukalski / @Guardians of the analog collaboration pcb. Now, I’m not a dirt pedal guy as general rule but, I’m really getting along with this one to push my amp. The SD-1 was always my favorite overdrive on the rare occasion I’d use one but, the...

Technically, you are correct. Precise voltage conversion is dependent on input impedance. In the audio world, it’s an assumption, based on the old telephone standard of 600 ohms.

You can measure the the ac voltage of the signal with your scope or multimeter. .78v is 0db

Sounds like your bias is off. You can use this site to generate and feed a sine wave into it. https://www.szynalski.com/tone-generator/ Set all knobs to minimum. Probe pin 1 of q5 with your oscilloscope and adjust the bias to a clip free wave form at its peaks, while sweeping the manual knob.

More modulation! Wait… or do you mean more dirt circuits?

I think this is part of the problem. By the way… can something be done about that ratio?

Hey! Someone built my thing. Sweet! I’m glad you’re digging it 🤘.

Word.

I didn’t actually think about that but… yes 😂.

^^^ This guy knows what’s up ^^^

Nicely done! 🤘