Recent content by Chris420

Hey yes there is a bottom layer of white and top layer of gloss if you have the most updates version of my file it should have the layers already setup.

Thank you very very much for all the help so far, its very much appreciated. You all rock!! 🤘🏻😃

Just a cheap one no brand name on it.

Not really I do have one of those cheap solder suckers but Im not great at using them. Sometimes I can get parts back off the board but theres high potential that i will wreck the board by melting a bunch of stuff. I practiced on a few old mother board and desoldered everything on them but i...

I took all the wires off for now and I’ll try again hopefully I will have more luck this time around hehe🤞🏻

Thanks! that was a helpfull thread I noticed one thing I did that doesnt seem to be needed on the foot switch. The way I wired mine was the same as the image below but the part I highlighted in green doesn't seem to be needed.

Absolutely my first build hehe. Ive done lots of Arduino stuff in the past but never anything like this.

Is this the two wires you were talking about?

Thanks! ill try that if i can manage to get the wires back off now lol

Heres more images of the board as close as i could get without it getting blurry.

No sound at all sadly.

Thanks for the reply :) I had to wire it that way do to the complications of my custom enclosure (the pcb was made for specific drill template that wasn’t the same as the original p melter pedal). That was the only way I could fit it inside although I wish I could have just mounted the pots to...

Thanks for the tips!! :) ill look into that stuff, the led legs are not touching anything just looks like that from the angle of the picture. I have a multimeter but I have zero experience with using it. Im more worried that i may have cooked the board. I leave my solder tip (low temp) on the...

Ok sorry, I moved the post into troubleshooting.

So I finally put my face melter pedal together and I sadly failed hard. Its not making any sound and the only thing that works is the foot switch led and another led at the top of the board next to the grounds for the jacks. The 2 leds on the middle of the board are not soldered on but they are...