Recent content by doubledre

in my post, I stated that I removed the cap and the mounting holes are still showing continuity which is why I'm wondering if the PCB itself has an issue.

Yes it is the same pedal. So what happened was I had realized that I used an incorrect value resistor for R21. It was suppored to be a value of 100R but I had used 100k by mistake. So I swapped in the correct resistor and that's when the signal stopped passing through. I got some help from...

I'm building the Chaos Pedal and have been trying to troubleshoot an issue for a while now because I am not getting a signal. After lots of testing, I localized the issue to the C2 capacitor. It seems to be shorting out as I'm getting continuity between the two leads however there doesn't seem...

thank you for pointing that out for me. I wired up the expression jacks again I followed this diagram as a guide. But both freq knob and Rate knob are still not functioning. Any ideas what it could be?

I'm having issues with my Chaos Machine build. I'm gettting signal and it works for the most part, except for the rate and freq knobs which don't do anything when adjusted. Previously, when I had expression jacks wired in, the freq knob was working but I decided to remove those wires from the...

Yes it is an on/on. did I buy the wrong switch??

I checked those componants and the resistors are measuring at the correct values, however my multimeter can't measure caps unfortunately. I did replace the the excisting cap with a another one I had and the issue still persists. Here are some photos. You can ignore the bypass switch as I...

thank you. I will double check those particular componants out. I wonder if I potentially burned one of the resistors or capacitors. Because the switch was previously working, however I used an incorrect IC (for IC2) and I spent a bit of time removing it using a heat gun and I was quite...

I'm building the Dream Fuzz pedal and I'm having an issue where the pedal isn't producing a signal when the tone bypass is switched on. But when switched off, the signal is going through and everything else works fine. I tried orienting the switch the other way, I made sure the switch is...