Elijah-Baley's latest activity

Meanwhile, I'll begin to build the board of the Big Muff, I hope within this week. :)

I replaced the Blend pot of the ROG Splitter Blend with a pan pot like this: But the two outputs are not joint, but each goes into an...

Thank you for your help and courtesy 🙂 First point: By blend I don’t mean a classic mix pot where CCW = 100% fuzz / 0% clean, noon =...

Inverting the phase was the thing I didn't want to do, I forgot it. Thanks, but these layouts (I like vero!) are blend. :D I don't want...

I'm sure Paralyzer is great. Actually, I built a modified ROG Splitter Blend with that same kind of blend, and my version has the blend...

Ok, I think I got what do you mean. Even if the connection of the Mini Blend Jfet has the input from the jack in the buffer/blend and in...

The JMK Panner was mentioned, but instead maybe take a look at the Paralyzer. https://jmkpcbs.com/product/paralyzer/ Replace the...

I thought it was like that, but after a gain/clipping stage it isn't properly a clean signal.

I'm afraid I didn't understand the connections you're suggesting. A schematic would be very helpful, please. And thank you.

But I prefer don't use a blend control, even the one you linked me I know works very fine. I'm reading that thread, but I have to see...

Well, I heard all that low end make is fine on the bass, but actually that's not the point. I mean, I built a few of two or three fuzz...

Thanks! There's a resistor after the Clean pot, but where exactly should I place the mixing resistor from the Volume 2 of the Fuzz? And...

Hello, I drilled the enclosure incorrectly for a different circuit, so now I want to use it for a Big Muff 2. This enclosure has four...

You gave up too easily :)

BTW, the final-final (I swear!) iteration of the RockBrain is Rev2 (renamed to RockEngine) and you can find it here. It's a little bit...