Recent content by erm

Bit shy about posting pix. Def a bit wonky in places. Feel free to school me. I'm here to learn. The misfeatures I know off: No LED, because I was impatient and couldn't decide how I was going to jam it in there. I'll save that for another day. No heatshrink on the jack lugs because I don't...

I swapped it out for another 3dpt and it's fine now. This time round, I waited for a bit longer between soldering the lugs, and tried to alternate the order around a bit, so I wasn't putting all the heat in one place. I'm using quite fine solder 0.5mm. It takes a couple of seconds to feed in...

Bought a kit, and some parts for a few pedals a year back. Finally got time to build the first one. Tested it - there's signal in bypass, but not when engaged. I traced the signal through the circuit and the signal is lost between lugs in the 3pdt. Between the upper right, and middle right lug...

@Route14 If you're talking about the larger full size 1590XX version, is the parts list different from the mini? If it is and you have it handy, could you post the parts list here. Cheers!

Unfortunately I put through an order just before it came back in stock. I found a few articles explaining standard pedal wiring. I think I can figure out how to build a test harness without a PCB. Probably good to understand the wiring better anyway. But I may pick up an Auditorium with my next...

Back in stock! Thank you pedal pcb elves.

Also out of stock! Another idea, would it make sense for met to get a Power I/O Module and 3PDT Breakout Board, and the components for an Auditorium and mount it on a block. Having everything labelled, and lined up might make it easier for me not to mix up the wiring. Is the fuse wired to the...

Hi all, I'd like to have a crack at building a few pedals. I've ordered a HPF/LPF kit from Musikding to start off. Having a test setup similar to the auditorium board seems like a good idea, but it's out of stock. https://www.pedalpcb.com/product/pcb365/ What are some good alternatives...