Fizz

Here is the Unicab I have been working on. I changed a few thing in the design for the case to make the wider board fit in easily and...

Sounds good.. Have you ever played the real SLO30? I'd love to know how they compare.

Did a simple demo with my telecaster.

Just finished it, tested and let it on for an hour. The the play test… what can I tell you? For me it’s the perfect sound both clean and...

I added a 10nF brightness cap from pin 3 to pin 2 on the DRIVE pot (VR1). I think it's a keeper.

Hello! I've been trying on and off over the past year or so to really try and nail this concept down and it has kind of driven me...

same here. i find tagboard layouts to be fun too. excessively large and impractical but i dunno, there’s a charm to it, especially...

Robot Trash Can Knobs are great.

I never would have thought these look so cool by viewing the pics on Tayda's website.

Tayda - KN8F. Make sure you get the correct shaft dia. Small Bear, Stomp Box Parts & Love My Switches also sell them. Price & color...

One thing about the Face Melter PCB: it's got a switch located right between two 1uF caps. That was a pain to solder. I had to use a...

This weekend I finished up a couple of drives. First up is Timmy the Enchanter (Tommy III PCB). I've never owned or played a Timmy...

Are sou sure about this? Pin 4 it's a GND and should read 0V, pin 8 should read around 9V (minus voltage drop on a 1N5817 diode). Also -...

Nice! I have a EGDM build which I haven't completed because of needing 2N5952s, I'll try the J112 in there, then mod it to a EGOD. :)

I love those knobs.. where'd you get them?