Recent content by fnoglob

now that it's done I agree, I was careful not to stay for too long on each leg but it worked really well, no problem. The sockets were already soldered so I let them in and soldered on top of them but for a next time I'll probably solder straight to the board. what about ICs? do you still...

I fixed it!! I'm not exactly sure what was wrong but I have a few leads: some of the transistors didn't make good contact, i ended up soldering them (very carefully) to their sockets and the trim pot needed to be adjusted, I couldn't adjust it before because i didn't have any sound so my guess...

I tried switching the in and out and that did nothing, I'll research more into signal tracing I don't know much about that yet, do you think the Q1 transistor could be where the signal is lost?

I've checked if the IC have voltage and they all have (idk if it's the correct amount but that's still a good news) HOWEVER... I have checked the transistors (all 2N5088) and they all have voltage on all 3 legs except for the Q1 which only have voltage on the right leg. I checked again without...

no sound at either end of the blend knob and the trim pot doesn't make a difference I hope the new picture will show what mistake I've made I'm pretty new to this hobby with only 3 pedal built

I've assembled a caesar chorus and... it doesn't work but not in a way that has been described here (at least I didn't see) all the LEDs turn on (they were backwards at first but that's corrected) true bypass works but there's no sound when the pedal is on The rate knob works, it changes the LED...