Recent content by forbesguitars

I checked the chips voltage. It looks like only one chip has a voltage variation on pin 3. I have attached a video. I will also recheck that lug on the switch

Solved. I reflowed the solder on the switch and it fixed it.

I pulled the board from the case I will hook it back to power from my protoboard and touch the spot in the picture. I almost looks like copper is exposed. I assume that is bad.

These are the readings. I am not sure what they are supposed to be other than trying to match the Vref to the right pin from the schematic. Sorry for my lack of understanding. I appreciate any insight as it is a learning opportunity for me.

I will double check The Vimex pots have plastic caps I will check the continuity on the jack to confirm. Centre negative I am assuming You may be right

I reflowed everything that looked questionable. I even swapped the chips just to make sure. I am not sure how to check the "oscillator". I should be focused on the TL072's right?

I will clean the board and check the joints. The jacks are mono, they are just the switched ones with two grounds. Thanks for the reply

I finished this build and it does seem a bit noisy. The issue I have is the white LED is getting some power even when not switched on. When on it does get bright? Any suggestions on how to trouble shoot this?

I have assembled this pedal but it is not working. Very little change when any knob is turned or switch is changed. The resonance pot is almost acting like a volume. I know it is pretty vague but any advice on where to start trouble shooting would be great.