genXslacker's latest activity

I’ve always “rolled” short pieces of wire between two flat boards to get them straight. Something like MDF scraps is perfect for this...

Thanks for chiming in. I've actually been reading through your experiences with it since I built it. I've already replaced Q1 with an...

The LFO on these by design will stall at either end of the rotation of the rate knob. I put a 2.7k ohm resistor on either end of the...

Genius! Going to try that next time. Cheers!

Ah, shucks. Thank you. Usually I use a scrap piece of vero that is cut or snapped about halfway through one row of holes. Put a good...

Looks stellar! Really specific question: how are you measuring the distance between lug 3 and lug 9? The connecting wire is really clean...

I agree, the lettering looks really good. A low profile lumburg DC jack would have more wiggle room. They cost a bit more, and have a...

We are cut from the same cloth.

I don’t really do graphics or themes unfortunately. If I did, my childish sense of humor would steer me toward a butt plug theme, so...

I have one of those in the bullpen. I'll bookmark @Jachiro's post. Depending on where you need the space, outtie jacks can frequently...

just finished my low tide modulator after staring at it for months now. i finally got all of the components acquired and sat down over...

As much of a pedal geek (RIP) as I am, nothing sounds better than a cranked '60s-circuit tube amp. But even in the rare situation that...

Drive Like Jehu is one of my all-time favorite bands and when I saw Way Huge had made a limited edition Jehu Drive combining their two...

They look like lava lamps. Just find a way to work that into a theme and you're golden. They definitely look intentional.

I’ve joined the cult! I don’t play much bass, but it sounds nice as a DI with my baritone. Keepin it DIY with some tricky drilling and...