I will check and let you know I know that that nut has been stripped out for years and I was trying to pull the pot out but when I get it out I'll let you know what it is
So you're saying that DIYLC can do it as well once I draw the schematic? Or do I have to draw the schematic with the components that they show in the component section and then I can move it around or is that program not able to really do it that way I do like the feature of being able to take...
What's out there that can do this? Without costing an arm and a leg?
I found DIYLC (it's nice for drawing a clean schematic) and thought that it said it could do it but I put in a schematic and see no way to convert. I see perf board schematics like at dirtboxlayouts and I want to be able to...
Maybe a good solution for this would be in the build documents where the drill template page would normally be just have a web-link to a 2,3,4, or 5 knob master template pdf so that way you would only have to update the one master and all build documents would lead to their specific knod number...
Okay mystery solved... I'm a bonehead! Let me just say that first of all.
So if you look at the two pages of the data sheet and it shows the nomenclature and you look and see well the one I have is to H2 and of course the H2 has a different pinout😲🤯
Well here's the reason I bought them, (as...
After I lay down last night I started thinking about some of the date sheets I looked at where it showed the pinouts were different and then I thought well maybe the big pin is not out on this one but then I thought well I've taken out the capacitor and nothing else is touching any of the 3.3 v...
Ok i got some good news and some weird news... so I removed the 5v reg and no change but the 3.3v reg got super hot!!! ah yes we are on to something here! So removed the 3.3v reg and walah all things are normal!!! put the 5v reg back in and yes we got 5v no problem... lukily I ordered 2- 3.3v...
Okay did a little searching and I found the schematic for the proto board here on the form The only thing is the capacitors aren't marked with what number they are on the board but I'm sure I can figure it out with a schematic hopefully the one I'm concerned about goes to ground and that's what...
Does anyone have a schematic for the protoboard? there's one spot next to the charge pump where some of the white covering on the PCB came off and some solder has joined it with the connection on one of the caps but I'm not sure if it's an actual connection there anyways or not thanks in advance...