Recent content by jwhitely

Cool!! This one is for a buddy. I may give a go at the Informant with the Charge Pump variation. We’ll see?!?! Definitely will be doing more!!

Got it back to working!! The black wire on the input Jack had a bad solder at the PCB. Still has some noise, but less than before, dare I say manageable. I’ll keep playing with it and see what I can do. Thanks again so much for all the help!! My next build will be a Kliche and I’ve done two of...

Okay, I I replaced the black ground wire you marked and re-did the signal wire and re-routed it. All was good with a little less noise, so I adjusted the routing of the wire up by the the input Jack and now I have signal passing when off (bypass) but no signal at all when switched on?!?! Sorry...

Cool. That should be fairly simple when redoing the other wire.

That’s clean!!! 🤌🤌 I’ll give that a try later tonight or in the morning and report back. Thanks again, so much!!

Not sure if this pic is any better. I hooked it up again and with the back off, there is a little hum that seems to get greater or smaller when I touch and remove my finger from the marked red wire (blue arrow). Any thoughts? And thanks for all the help!

Input Jack fixed this issue!! Thanks so much. Now to figure out the bad hiss noise when active?!?!

Are the input and output jacks supposed to be wired the same or opposite?

Will try swapping those leads here in a sec. Thanks.

Yes, switch is soldered. The quality of my soldering might be questionable?

Good afternoon. This is my first post here as well as my first non-kit build. Everything went together smoothly for the most but upon completion, I’ve got LED on and off with the foot switch but no sound at all. Anyone care to take a look at a pic and see if you can spot anything? Tried gently...