Recent content by laxu

Thanks! Will just run it at 9V.

Can the Duocast be run at 12-18V or does the charge pump design with the 9-27V switch prevent this? I would like to get something in between these settings and was hoping using 12 or 18 volts from my CIOKS DC7 with the Duocast switch set to 9V would do the trick.

The secret is out. Tone is in the black metal logos!

Ok so I finally had time again to work on this and I got the Pro-10 Green finally working. I had to swap the whole damn switch to do it because no matter what, the tab for the LED would not get connected correctly. I am also so done with the PedalPCB 3PDT breakout boards. They are way more...

I cleaned up some of my joints and tried to resolder some of the legs on the switch but alas no luck. Pro-10 Green works great but LED does not light up. I can get it to light up if I hook up the 9V then use my DMM to probe from 3PDT central leg to SW connection. So the LED itself works, just...

Sorry for not providing pics before, I wanted to see if I could get it running reflowing all solder joints with a proper soldering station. I ended up redoing a lot of them as I was not happy with my previous work at all. Now both my pedals work! No noise issues, switches and pots all work and...

Yeah I just boxed mine because I wanted to trim the cables right but it's a bit of a chore taking them in and out. I think I need to grab some screw in connector for hooking up the DC power so the whole circuit can be taken out since the power connector goes in the other way. Still struggling...

Both Pro-10 boards are missing schematics.

I got the Pro-10 Blue working. I hooked up the black cable on my multimeter to the power jack ground and then used the red to see if there is voltage through the pedal when it's on, measuring at the 20V DC setting. Found some resistors that were not correctly soldered and after going through...

Build a Pro-10 blue and green using Musikding kits. So I guess this is some issue with the switch but I can't verify until I can get a better soldering iron because my current cheapo does not seem to fare well with lead free solder so that might lead to cold solder joints or some other issues...