Recent content by Morgoth

Would really love to have that pedal. There was a thread about that pedal, but has been recently deleted (why?).

Nativebobcat, I've sent you a PM. In case anybody else needs the answer I am also posting it here: 2 is the tip, 3 the awitched tip, 1 is ring. Sleeve is the lug on the front.

I got the anwser - I asked nice people from Musikding, where I bought the kit and they provided me an anwser. The pedal now works like a charm :)

Hi, can someone please help me how to wire the epression jack to the pcb? On the attached picture is my epression jack. It's pins are numbered from 1 to 3 and 5 (4 is a empty hole). Thank you and best regards.

I received a new switch and replaced the old one with it. Now it works like a charm. Thank you all for help!:)

Thank you both! i will just order a new switch and hope it will work.

I've measured the voltage on the center pin and it is 3.3v, on the perimeter pins the voltage was always 0v on all positions. The resistances are around 100k on all 3 pins. The diodes are like this: D1- around 0.296, the rest (2-10) are from 0.706 to 0.716. I did some additonal testing with my...

Hi, Isn't you L78L33 turned the wrong way? I'm not mistaking, the round part should be facing down not up. I'm not an expert so please someone correct me if i'm wrong.

@phi1, yes i get the reverb sound if the mix pot is not at 0 (100% dry), so the mix pot works, and so does volume. I also found that the dwell pot (control 1) works (it changes the length of the reverb), if I turn control 2 i hear some funny (kinda pitch-shifting) sounds (while turning), but i...

Ok, I will build an audio probe. I need to order some componets first. I will let you know how it turned out, when i get the components and build the probe.

Here you go.

Yes a rubber pad is glued to the bottom of the volume and mix pots. Also i didn't see any pads connecting to each other (two pads soldered for example)

Here are the pics Yes, the the mix knob works and so does the volume, i also found that paramter 1 (dwell) works. I know how to make some basic measurments (for example check the voltage) with the multimeter. But i don't have an audio probe.

Hi, I've build the spatialist reverb pedal, but it doesn't work. All 8 programs are the same (nothing happens when i turn the pot), none of the upper controls (parameter 1, 2 and 3) seem to work, although when I turn the parameter 2 pot while turnig I hear some funny pitch shifting noises. But...