Recent content by motoburn

Sorry, not yet. I ordered a desoldering tool, but then ended up sick for a bit then work has been chaos. I am hoping to get back to it soon. My suspicion is that I didn't do a very good job. My other two pedals (made after this one) turned out great, so I plan on checking every connection

Sorry I missed this post. Thank you. I'll check these

a couple of them from Tayda had the dustcovers but the other ones didn't. for testing I have them bent upward so nothing is touching the casings. For now, I'm waiting for some desoldering tools I ordered and am going to get the bulky items out of the way, check each of the other components...

ok, I replaced that resistor and my initial concern has returned... idk what's going on, but now when engaged, I get clean signal but when I roll the Mix knob all I get is static

Thank you any suggestions for replacing it around the Belton and C17?

huh.. well my DMM seems to be on crack... bought in '98 at radio shack.. but it seems to be .47 M as the reading which definitely suggests you are correct. I don't know the colors, but with my eyes I could easily have grabbed the wrong one. So it looks like i need to swap that one out for the...

I just put power to it again and the static is gone, but not much in the way of an effect when engaged. I now have a staccato (single short) heavily clipped audible coming thru if I dig in, but silence otherwise.

thanks I'll hold off trying to extract. Yes, right now they are bent upward to form and air gap, so I know they aren't touvhing anything

Hi, this is my first build. Clean bypass sounds fine, but when I engage, all I get is static. None of the knobs seem to affect the static except for the mix knob. Can anyone help me with a starting point for diagnostics? I assume I'll need to get that BTDR out of the way so you can see my...