Recent content by passtheducky

  1. passtheducky

    Jlcpcb and tariffs

    oof this is going to suck
  2. passtheducky

    Pre-delay vs ducking

    For slaps or very short rooms, predelay does a good job of what you’re asking for. Ducking can unclutter things when using long decay times.
  3. passtheducky

    Fuzz Face Clone

    Works to fatten up tone benders too.
  4. passtheducky

    SpinAsm IDE issue with decimal numbers

    Was it expecting you to use a comma for a decimal point? I have never seen that in an IDE.
  5. passtheducky

    Looking for .spn files for use in Disting NT

    Sure, I'll take a single origin Ethiopian coffee. There's a thread on modwiggler with the background on this project, which might be a more appropriate forum to discuss further. https://modwiggler.com/forum/viewtopic.php?t=242154
  6. passtheducky

    Looking for .spn files for use in Disting NT

    I have a repo of programs that were designed for a FV-1 based synth module. You might find something you like there. There are modulated delays, FDN reverbs and some Lexicon style reverbs. The Lexicon style verbs are based on the Concert Hall, not the ubiquitous Plate algorithm. They were...
  7. passtheducky

    What's this JFET doing for me?

    Yea. That stage has some filtering and a gain < 1, as it has to drop the level a bit to go into a codec.
  8. passtheducky

    What's this JFET doing for me?

    I cargo culted an input stage for a pedal I'm designing and was a little surprised when I measured it. It's a JFET (2sk208) set up as a source follower into an OPA1652 in an inverting topology. The THD was something like -43db, mostly 2nd and 3rd harmonic. I fussed with the bias and was able to...
  9. passtheducky

    Kliche - diode removal?

    No this is fine. It’s just a hugely over complicated boost without diodes.
  10. passtheducky

    Fuzz Face Build without Knobs .... Help Please

    Wire a resistor the same value as the pot between the 1st and 2nd pin and jumper the 2nd and 3rd pin. Try not to get it backwards.
  11. passtheducky

    All Tayda pre-drilled, powder coated enclosures out of stock

    I just finished five enclosures on the drill press. This gets old so fast.
  12. passtheducky

    Terrarium Polyphonic Octaves Code & Demo

    Amazing work. Great explanation of the algorithm too. I have some Daisy pedals I’ve made. I can give it a whirl at some point. It’s interesting that it doesn’t shift the high end. Just focusing on the fundamentals and maybe the first few harmonics must really mellow out the effect. Would...
  13. passtheducky

    Terrarium Polyphonic Octaves Code & Demo

    Ah, was not aware of that particular octaver algorithm. Sounds really interesting. Did you derive that code from the paper or was it already published somewhere?
  14. passtheducky

    Any true stereo circuit (chorus?) to implement after a dual mono drive?

    The Dimension D circuit might be what you are looking for in a stereo chorus.
  15. passtheducky

    Genuine Question - What's going on with the noise complaints with the Electro-Smith?

    The problems that people have had with the Daisy are more or less the same problems that people would have with any other comparable platform, based on their use case and their level of expertise.
Back
Top