Recent content by paulc

And for R9

Don’t forget to change R9 to 3k3 along with R10. Also to make the mid control a little less “peaky” you could lower the “Q” by changing the 2k2 resistor to 3k3 and the 1n5 cap to 1nf. This will give the same center frequency but with a little less gain and a little broader bandwidth

I built this around two rigs. One was strats with princeton amps, and the other was LP’s into plexi’s.

R9 should be 3k3 Also change R10 to 3k3 to bring in some more highs at the expense of some bass boosting from the bass control

That circuit adjusts the treble from -3dB@7khz down to -3dB@450hz

Taking a quick look R9 should 3k3. That will tighten up the low end a bit. C10 and R10 on the output amp form a de-emphasis filter that works with the bass control. Changing R10 to 3k3 will bring back some highs while reducing the max bass boost setting (unity bass is when the bass control =...

Just for the record this isn’t a Klon style pedal. Bill F is a good friend and I’d never rip his pedal.

If this is the pedal I think you may think it is it came out just over two weeks ago with a small batch to start. There’s not many out there and none were given out to YouTube guys for demos.

The Timmy never used a B1M. It should be Audio taper. A500k is fine - that's what was used in the original Tim and now the V3. For the past several years the vol was a A25K pot with an 18k resistor soldered across input to wiper. This altered the taper to put it at 25% at noon. PaulC