Recent content by perfboarder

always bend the lead (or use solid wire), connect that on circle side. No need blob, even 2 component side by side,. So, if you want/need replace component, you just cut lead in between. But i know, almost all perfman rarely do that. We build and leave it is, until broken. Also, recommended use...

still on free 7.7 because enough dual layer and 1590BB size. And maybe muscle meory, coz its easy to perf. If i need 4 layer or big size, turn on Kicad.

just click arrow on top right of document or go here

yeah, nice sounding circuit, but im ended with tone from fuzzdog pitbull. I think i need build scarab original spec again to remember difference.

on that product page, there 2 pdf, build doc and drill or get here. Or (again) you can ask at hotkits fb group. iirc, hotkits from Russia. I think Alex Hotkits use alixxx as username at guitar-gear ru.

from fsb thread. I just come here from @rwl github page. OOT. Thank you, both of you for rockman!

so, basically just modified EWS little brute drive with output buffer?

Nice Muff. And how tight the secret muff? I think closer to dylan159 bigger muff. Yes?

Nice wood-point build! Had commision (3 pack cigarette!) perf layout Muff Triangle pots 1590B top jack with MPQ or wannabe symmetry trannies. But my friend build on 125B. He frustated about precision drilling. Hahaha

Almost use bromus for every steel drill and lathe. From motorcycle crankshaft to cheap chinese thin hammond copy.

component name: male female pin header. Easy removable. my experience, sometimes get loose. I do like reinforcement solution like @Brett did https://forum.pedalpcb.com/threads/mos-tron-envelope-filter-dylan159s-chewborg.21961/

My problem with (bufferless) YATS is tone pots. Must be W-Taper. And then Mr Wiltshire came to rescue. Or we can build scaled version if we dont have exact pots.

small size DIY? Perf-ing CrapFi delay. Easy, low part and can be pt2399 tester. Madbean cave dweller also candidate. If you 1590A masochist, DelykPcb have deep blue delay. OR go wild with Noise Ensemble.

Maybe you need build/get jig, suited your punch. That slightly off because your angle view when punch and drill is different.

I did build derivative circuit in 1590A, just because only have 2 9mm B100K pots at that time. Iirc, from Mark Hammer.