Recent content by Peteus

You were absolutely right. I placed the cables together and it worked. I have since then wired up my switch audio jacks with the always-on tip to the left hole and the other hole goes to the switchable tip. I.e. when the cable is inserted they disconnect. As soon as they disconnect I get lots of...

I think that maybe it. How do I determine which is the switched tip and which is the tip on the switch jack. I have only just discovered there is a difference between the types of jack.

Cheers, I wish I'd read those before starting. I'll get a printout and start trying to get my head around it.

I'll give that a go. Will the IPA just clean up any residual flux? Should I remove the IC and transistors before applying IPA? As a person who at the moment is placing parts together much like a Lego kit, any ideas on learning the specifics of how the kit works?

I just tried 4 cabling it so key in thefront of the amp and the in and out the amp through theloopthe noise was horrific. A very loud hum went through the front of the amp. I'm guessing that is where the issue lies. How would I go about diagnosing this further?

Hey, I'm having issues with the muzzle build. I soldered everything up minus an issue with a few resistors being incorrect from the kit I bought. I've gone around the board and checked all the resistors and gotten them installed correctly. I had issues with the pedal almost killing the whole...

Anyone heard any news?

Does this mean it's in progress?

I'm glad to see I'm not the only one :)

What's the likelihood in the KSR Ceres pcb being available?

Who would you ask, to find out an update on this?

I'm really keen to get get a clone :)