Recent content by redclover7!

The solder side looks ok but I was having a hard time soldering said break out

It is a tape delay

I might send this off for troubleshooting, and start another, it gas sound but chaotic.

Anything obviously wrong here?

Can I ask about troubleshooting a build aside from pedal pcb?

yea i can drill a hole thru my wall in garage then tool for some kind of exhaust fan that's the easiest solution to remove fumes to outside

Monotone I use a cheap meter

I see 110 ohms, but my meter tells me 100, what would you say?

Yea it's because it's for mushrooms to thrive ,,I think I will get a carbon filter type or even solder outside,

I use this for mycology, probably not appropriate for solder fumes! It has a hepa filter

Can solder film cap to underside since trace pads are still good there? If there is continuity?

I can check for continuity? To wherever the traces run? Can i install part on backside if trace pads are present on otherwise as to ensure connection? Thx

I think I melted another pad, is it ok? It's because I had to desolder a misplaced resistor

I am watching tonight thanks