rossbalch's latest activity

Yup. That EQ curve is magic on guitar, gives you more of what you need, and less of what you don't.

It's important to think about ratios in audio though, the difference between 250k and 500k would be quite noticeable, but the difference...

It looks like a tremolo effect where the LDRs are used to variably shunt signal to ground, I would say the difference between 500k and...

Maybe the GL5516 instead then? https://www.pedalpcb.com/product/a2002/ The tricky thing with the photo resistors is that the rise and...

The TY-141p may have a worse frequency response on paper, but based on the testing done by some people over at GroupDIY the 141p extends...

Also worth checking out in the "Indiana Tweed Overdrive" a Wampler Tweed in a box.

I used to use a Strymon Flint on the plate setting and it was pretty good. I usually use it set quite low and I like it. right now I...

It works on the pedalpcb website as this thread was intended for, but you probably mean the forum one which is probably under construction.

Regarding the transistor, the letter at the end of the transistor often indicates the gain range of the transistor. Manufacturing...

I just posted that link because I found it interesting in general, also as a showcase of how far some people are willing to go :) And I...

It's all pretty much that yeah. Just didn't want to create a new thread.

Thought this might be the best place for this rather than a new thread. Received an email from Mouser today. Does anyone care about...

The thread you linked earlier was pretty long. For a non engineer like me, what's the TLDR, are filter caps sufficient or is the ferrite...

Hi fellow kiwi! I've also switched from Mouser/Digikey to LCSC due to price increases. I went for the Microchip TC7660S due to the 45kHz...

I paid NZ$4.90 ea for a lot of 10 LT1054CP in July, already they are NZ$5.48 for 10. This must be tariffs right? One of the reasons I...