SamuelG's latest activity

From what I have read today they are all closely related along with the SLO 100, Van Halen used the SLO 100 which is what Peavey used to...

Here is a sample of my updated MOD for the Bathtup Reverb. Note that the Dry path stays clean: [This is my original case, not my...

I haven't tried it yet myself but when I do it will be on a new PCB, I just wanted to point out the possibilities that exists with the...

Ooooooooo, I like the idea of turning the Bassdude into a JTM45!

The Fc of 180Hz has been my favourite for Bass. It's a very low slope but still removes the mud.

So, in terms of simply bending the pin, that would work well. However, I needed to cut Pin 3 because I had already installed the module...

Good question, I’ll check my notes. My current build has a 1uF in place.

So, after a pause to re-do my Bathtub Reverb MOD, I've now integrated the idea above [thanks Mick]. I have adjusted the circuit so...

Yes. It's what I used for all of the builds.

Note that I shorten pin 3, then mount pin 3 to the board via the 0.015uF cap. All of my shileded cables are grounded to pin 4. Next time...

Two reasons for the high C2. The main one being, that's what I had on hand :) The second is that I tend to let pedals have a specific...

Oh, a C2 of 0.68uF also works and will give an Fc of ~15Hz but I didn't have one on hand.

Okay so after three different itterations I'm finally happy. To replace C2, I put in a 1uF 400V cap mounted on the underside. [Not...

I’m now working on applying the Fc switch to the wet signal but not the the dry path. Been busy lately so slow progress.

Oh, by the way, I'm in the middle of trying different values for my coupling capacitor. I'm still not happy with mine (the fc of the...