shawnee

Thank you so much. I will have to build one and see what I get.

The JFET in this circuit cannot be properly set up if it is not in circuit. However, it can be properly selected by measuring the...

I don't have a Peak. I'm just measuring gate to source with the J201 in circuit. How do you bias the JFET if it's not in circuit?

The -1.0v is from gate to source. The 6.4v is from gate to Gnd. I could swear I was getting -1.0v but now I seem to get 0.15v gate to...

The voltage at the gate doesn't matter so much in this circuit. The JFET so used in this application acts more like a fast-reacting...

The JFET will not interfere with the Gain aspect. The JFET is there for the compression when the Gain is turned down. As the Gain is...

Thank you so much for the reply! I really appreciate your time (and knowledge). All IC's have approximately 8.5v on every pin except pin...

If the main rail is ~+17V, that suggests you are using the chargepump in this build. If that is the case, there should be ~+8.5V at pin...

Thank you so much for the reply. I'm getting about -1.0v on a different J201 but still getting about 6.1v on the gate. Does it matter...

Hello and sorry to resurrect an older solved thread but I can't seem to get my Proposition quite right. It works but it doesn't seem to...

Hello everyone, I just finished building the Proposition Distortion and it functions (passes affected signal and all controls work...