steviejr92

Here's a project contributor's new build, using a fiberglass fascia plate made by JLCPCB: Everything sourced from JLC or Tayda, and...

I haven’t had too much time to play with it, but my first impression is this is a righteous drive pedal. It’s a variation on the old...

thats my spot, #2 :poop:

I'll bet there was mucho shit involved!

I'm almost done with my Unicab and I'm unreasonably excited for it! Also building just about every preamp and amp sim I can find to pair...

Use to put something similar on male sheep, took a couple of hours for them to settle down!

A lady I used to work with talked about doing that on her boyfriends farm..... then would continue on to mention how the sheep didn't...

Something Like This:

Hey hey hey......watch it there Raoul.....bingers gotta binge doncha know? We're a protected species.....

Thanks guys! I try and take my time

That was quick!

Nice! Do you run your own fab to get such a quick turnaround time? 🤣

I strip the wire about an inch and wrap it around the legs a couple times, solder it on, trim the excess lead of the LED, then heat...

I mount my 5mm LEDs in a chrome bezel. If the LED leads can be more-or-less straight from the board to the bezel, then I omit the...