stvmgn

Thanks to all who helped me figure out what my issue was with my bi-color LED, I have been able to successfully build my first pedal. A...

Got it. For others benefit, I did up a small wiring diagram. This was using a 3pin bi-color LED with a center cathode and two anodes...

This was the part number on my invoice: BL-BHG204 Looks like this is the data sheet...

Here is the dual led I have.

I changed the red and black wires around on the dc jack. I also removed the connection between 4 and 6 of the switch. Now I can get a...

The switch is wired like this: Post in thread 'DIY Stereo AB Box' Here is another angle:

Apologies. Thread 'Stereo AB Troubkeshooting' https://forum.pedalpcb.com/threads/stereo-ab-troubkeshooting.23976/

Hi there I can’t get the led to light up when 9v is applied. It will light up dimly when test continuity with any of the dc jack lugs...

I can’t get the led to light up when 9v is applied. It will light up dimly when test continuity with any of the dc jack lugs and the...

@joelorigo were you able to confirm your above wiring works? I am interested in a stereo AB too.

So, I made a mistake in mounting the slide switches. I mounted them too short. I got confused. Instructions didn’t talk about it...

It doesn't seem like the dpdt on/on/on can be used. The schematic from the dp3t datasheet: Schematic of dpdt on/on/on: Schematic from...

Could a on-on-on toggle switch be used rather than slide switches? The slide switches are DP3T and toggle switches seem to be DPDT so...

That might actually work. Drilling the larger holes in the enclosure and putting the switches flush against the faceplate. Smart. I...

The body of the switch is directly against the enclosure. The problem is the actuator height of the switch is too short. It’s 3mm but...