swelchy's latest activity

I believe what you seek is refered to by the youths as a "selfie stick"

Hi all, I got into pedal.building the last 2 months or so and this is my first real pedal build. I put a Rat and a Klon into the same...

This was my after-family thanksgiving project. I was going to make a kliche with this enclosure but the delay is cooler. I made it...

Make sure there's nothing going on here, just to be safe: EDIT: Actually, disregard.... both of those pads go to ground so a solder...

Yes... there was a tiny sliver of solder there.. when i reflowed yesterday i picked it out with a hobby knife

At Some point later when I get annoyed by all the people in my house I'll retreat to the dungeon and signal trace the non working one...

Removed the three "Effect/On LEDS" on both builds.... One of the builds functions correctly with the leds removed... Looks like the...

Thanks for the alternative Build doc. I was going though schematics and aside dpdt/3pdt arrangement, only difference that i see, is 1m...

yes i realize he has the leds soldered on the incorrect side of the pcb... but he has the polarity correct..... I'll pull them and clean...

question: just going over the build docs... The DPDT switches he has are ON/ON/ON for all three on each build... The build doc calls for...

yeah... deep dive.. I hooked some new leads and threw both builds on the auditorium test board... both will get bypass signal from...

Board #2

Board 1

went ahead and pulled the wires that were installed.. Reflowed every single joint on both board and scrubbed them down with 99% iso...