swelchy

oh... and good luck with the electrical tape for the pots.. that almost always causes issues.... your better off with some thin hard...

I'd also check out that capacitor while your back in there poking around.. looks a bit suspect.. Appears it got some of the hot poker...

I just wanted to see what the hype was about with this circuit. I actually liked it more than I thought. I will probably keep this one...

show us your gut shot or we'll get you....

you can desolder the diodes and put sockets for switching out diodes... or solder in wires and add a switch to switch between a couple...

just don't do it.....You'll regret it that they all have nice uniform colors and will look pretty good in a build.

same..... but the way I wired it made more sense to rotate the lugs 90 because the spacing of the 6 wires was a bit wide... I think it...

multimeter set to DC volts.. black probe on a ground pad and the other red probe on the pins youll be reading voltage of... take not on...

bwwwwwwwwwwwwwwwwww Read the troubleshooting sticky... Then get a multimeter and give a voltage readout for each pin# on all your...

I didn't go overboard on the mojo parts.. used what I had.... I was tempted to order Dale resistors, Wima and Nichicon caps but decided...

Your resistors are to parallel to the PCB to achieve the true klon tone. 🤣 Well done. Authentic magic diodes too!

Finished up this full size Klone for my board this morning… Everything went pretty smooth. Sounds really good too..

while your in there it also appears your pots are not insulated and could cause a short to the pcb.. or maybe they are and I cant tell..

That's freaking sick!

So I finished this a little while ago and just got around to doing a bit of a demo as well as trying to capture various parts of the...