Tassieviking's latest activity

  • T
    Tassieviking replied to the thread King Nothing Not Working.
    That seems very strange, the only thing I can think off is that you have a faulty switch. When you have the pedal off can you put a...
  • T
    Good to know that Taydas 1590DD is too thick walled, but the drill template would still be great to have in case I want to make a fascia...
  • T
    Vigilante398, do you have a Tayda drill template for the Supersonic? I think that one might be a bit hard to do by hand so I will have...
  • T
    Here is the drill template from Tayda, all dimensions are from the middle of each side.
  • T
    Tassieviking replied to the thread King Nothing Not Working.
    It would appear that you have a broken trace on the switch PCB in my opinion. Pin "C" is connected to pad "5" by a trace on the PCB and...
    • 3PDT- PCB mirrored.png
    • 3PDT-TB Front PCB.png
  • T
    Tassieviking replied to the thread Transformer search.
    If you do find a smaller cheaper transformer I would love to know what it is, I also would love to make a tiny amp but I would like the...
  • T
    Tassieviking replied to the thread King Nothing Not Working.
    Can you check the voltage between pin C (5) and pin D (6) on the switch PCB, C is the earth and D goes to the 1k resistor and then to...
  • T
    Tassieviking replied to the thread Transformer search.
    This is a small story that might inspire you to look at other types of transformers. https://www.ozvalveamps.org/optrans.htm You might...
  • T
    Tassieviking replied to the thread Lab Rat build!.
    Not for a normal RAT, but since yours has a tube buffer after it it might still be nice, I would have to build one to know but I have...
  • T
    Tassieviking replied to the thread Lab Rat build!.
    Or middle can just be like a nice buffer as long as you don't crank it into clipping the OP amp.:)
  • T
    Tassieviking reacted to vigilante398's post in the thread Lab Rat build! with Like Like.
    Up is LEDs, down is diodes, middle is none (op-amp clipping)
  • T
    Tassieviking replied to the thread Lab Rat build!.
    Up appears to be the LED's to me, just my opinion. If you zoom in on the build doc you will see the switch is upside down with 1 on the...
  • T
    Tassieviking replied to the thread Vampire Slayer DIY PCB?.
    `I just checked the PCB to the schematic, component ref's do not match so follow value on PCB's I would say. 27k resistors should be 2...
  • T
    Tassieviking replied to the thread Bass Dude.
    Before I build any PCB I have ordered I usually trace the PCB to get the schematic, I get a better "feel" for what I am doing that way...
  • T
    Tassieviking replied to the thread High Voltage Power Supply.
    I would love to see the schematic on that 3 watt amp, I would love to build me a small tiny amp and run it from your HV power supply. I...
Back
Top