Recent content by Teddeeh

Does anyone have any tips, tricks, rules or guidelines they adhere to when drawing a pcb? Better for noise, routing etc? Im still learning but some pcbs i have made im still gettting noise issues etc so would love to hear what people tend to do to ensure the best product at the end of the day.

In a 4 layer do you dedicate one layer to only ground, or only have the ground on that layer?

does anyone know if the schematic on the ocelot board pdf is correct for rev 2 or the original with issues? could anyone look over my schematic in diptrace to check for me as i did have issues with the board i made.

ok, makes a bit more sense with that. is there any magic to part placement or anywhere i can find some do's and dont's? im noticing im getting alot of noise through some boards i have made, even though i have connected the grounds to main ground plane. i didnt know if i was connecting 2 circuits...

Would @Robert know more about diptrace? I think i do remember chatting about diptrace a while ago with him.

So im wondering how to get different ground routes in diptrace. I see there is a common ground attached to the ground plane, but there is also another ground that is attached to the ground at some point but dosent clip to the ground pour. Can anyone help me out? Ive made a couple of pcbs so far...

hey y'all. so i want to build a stripped down octave pedal using only the octave 1 of the ocelot and the direct signal. how much from the schematic can i effectively remove to eliminate part count for a new pcb?

any update on the angry andy plus scheme?

it was the scheme i was after, particularly the boost. i have an actual JHS at+ that i bought brooken and its the boost section i need to look at.

Is it poss to have the angry andy plus/ AT+ scheme?

i did have a bridge on the one that just didnt work, but yes, both pedals and a number of others failed to test. i thougght i was in a bad luck spot or had a dud batch of parts, so i went through testing all components that were the same. but then i tested a pedal on my pedal board and vola!

it was the power supply. second electro harmonix 9v to within 2 years..

pi d3 looks like 0.3v

apologies on lateness i have had too much on to get to these. so i figured out one issue, bad psu. electro harmonix psu failed giving off readings. changed and alot of duds are now working but still the great sea that wasnt powering on atall still is failing. will check voltage levels momentarily

Top is the one that atleast powers on. Bottom nil power