temol's latest activity

  • temol
    temol replied to the thread Resistors sourced from Tayda.
    I find them better than resistors from Aliexpress kits. They have thicker legs which I use then for breadbording (jumpers) and as a...
  • temol
    temol replied to the thread I need a new step bit.
    I buy them from Aliexpress. 3-12mm, 1mm step. T.
  • temol
    That's why I prefer "regular" pots, with some wire (cut off resistor leads) soldered to the legs of the pot. It allows to compensate for...
  • temol
    temol reacted to Fuzzonaut's post in the thread Parentheses Fuzz with Like Like.
    Here's my Parentheses, built on the first version of the PCB. The 5102s were on back order for around 6-7 weeks, so while the almost...
  • temol
    temol replied to the thread JFETS, matching etc..
    Can you take one of the J201 transistors and make comparison of Vgs readigns from DMM method and transistor tester? T.
  • temol
    temol replied to the thread JFETS, matching etc..
    Those jfet readings are from LCR meter or DMM? Suspiciously good as for ebay 201's... T.
  • temol
    temol replied to the thread JFETS, matching etc..
    Cannot view the file - "You must be logged in to do that." T.
  • temol
    temol replied to the thread JFETS, matching etc..
    I've never worried about any protection because I have dedicated adapter for smd, socket for through hole and I do not mix bjt and fet...
  • temol
    temol replied to the thread JFETS, matching etc..
    You can also try "circuit" described here (bottom of the page) http://www.runoffgroove.com/fetzervalve.html Also here -...
  • temol
    temol replied to the thread JFETS, matching etc..
    Ok.. Tayda jfets are jfets.. thats' t the meter probably. Those cheap LCR meters are not the best choice for JFET measuring. I have one...
    • jfettest.jpg
  • temol
    temol replied to the thread 12R4 resistor value????.
    It's 12,4 Ohm. M, K or R letter between digits replaces comma (M-mega, K - kilo, R - Ohm). T.
  • temol
    I use almost exclusively MMBF/MMBFJ transistors but when possible I prefer to have through hole footprint. It's easier to swap...
  • temol
    temol replied to the thread Why It doesnt works?.
    I'd check this spot first. T.
    • solder1.jpg
  • temol
    temol replied to the thread Must Have Distortion Pedals....
    It would be nice to see the Palladium. It's been available for quite some time and still no schematic available T.
Top