Red-G and Green-G on JFETs?

Does that mean it needs to be measured with the proper colored lead? I think it doesn't matter on my Peak DCA75. Why does the last JFET have green instead of red?
It's just what color Robert happened to be used on the Gate
Doesn't matter.
 
Useless information that should have been omitted from the docs...

That is the DCA75 identifying which pin each lead was connected to at the time of measurement.

If you were measuring an unknown transistor that would tell you it's pinout.
 
No, it absolutely does not have to be red. Any probe will work. It just so happens that this particular color was connected to the G (gate) terminal. In the case of JFETs, the location of the Gate matters, but the Drain and Source are interchangeable, so the colors don't matter there. If it were, for example, a BJT, then three different colors would be specified—one each for the E, B and C.
 
Useless information that should have been omitted from the docs...

That is the DCA75 identifying which pin each lead was connected to at the time of measurement.

If you were measuring an unknown transistor that would tell you it's pinout.
I do computer programming and have to follow EVERY instruction :LOL:
 
Back
Top