vigilante398

Just finished updating the build doc, the only thing missing (as usual) is the drill template. I'll get it uploaded when I get home from...

I use them and they fit just fine on my GTO build. There appears to be about the same clearance on this design. They also act as bumpers...

Pretty sure it gets done for the same reason as on an EF86, based on my understanding of sheep and pentodes.

I appreciate the design is already using the available space inside the enclosure, so this is one of those "great if it fits, but OK if...

A solid question. They should tamp down the microphonics a bit, most EF86 amps I've seen use the dampers on the EF86. I have some around...

Well I'm getting an error every time I try to heat the bed up to print ABS, looks like I may be in the market to replace my wizmaker...

Something Like This:

Nice one. This is one is definitely intriguing. Did you mention the tubes because you’ll be selling those as well?

Hehehe. Looks great, I'll be grabbing one for sure.

I wasn't planning on it, but maybe I could? I used to sell an EF86 pedal so I stocked up on tubes, then I discontinued it and was left...

Alright, I kind of teased this one a bit ago in the Echo Foxtrot thread as this is the reason Echo Foxtrot has been discontinued...

I have, and the "commercial" Black Eye that I sell has a baxandall (james) stack with a bass boost switch for flexibility, but that's...

You may not be picky, they may just not be good. There are a plethora of starved-plate "tube overdrives" out there that are less than...

I keep seeing ads on facebook for the Bambu, pretty sure it's your fault. I don't need it I don't need it I don't need it I don't need it

TOASTER OVEN. That was the main piece of advice I was given back when I started doing rattle can finishes. I picked up a toaster oven...