Recent content by wsscott

JRH--Did you ever get yours working? I've got the same problem as you. I built a Classic Delay Pedal from buildyourownclone.com, and it works great. So then I got this board, and built it, but no delay effect. If I turn the Delay pot almost fully clockwise on the CDP, I can get some delay...

MicMac-I just tried out your suggestion and it worked great-just as you described. So I guess things must be calibrated ok. I played around with the settings, and finally after all these months, I finally found a great setting for me for a SlapBack Effect. That's why I built it to begin with...

Sorry, but I'm mistaken on the switch. Actually Short is UP and Long is Down, as I installed it.

Thanks I'll give your short mode suggestion a try. I wired the Long/Short mode toggle switch like its shown in the instructions, but I've seen different photos of builds with some showing Long with the toggle in the UP position, and others with Short in the UP position. Which way should it be...

Oh, I meant to also comment that the "On" LED that I'm using is white/clear and it's really bright. The Red/Overload LED's brightness is fine. Any recommendations on how to lower the intensity of the ON LED? I assume adding or changing a resistor. Any suggestions. Thanks.

I got my pedal working late last summer. It turned out that the trim pots were too low to output any sound, so I worked on getting the 3 BDD's "tuned". I found that the pedal does well when it's in the Long position, but when I turn it over to Short, there's barely any effect unless the other...

Benny-I got this kit last week and completed the build, but I can't get any sound out of it with my guitar plugged in. I do get "sound" when using injecting a 250 HZ signal from my iPhone's sound generator app, but its just "noise" and the Output has to be turned up to about 2 o'clock to get...