Recent content by zeitguy

I did see it. But I used a B1M dual gang pot so I left lug 2 and 3 open, no solder bridge.

Hi everyone, just finished this build and it works great, the trims are all set and all is good... Except that the bass pot doesn't do anything. Or it's so faint I can't hear it. I know it's supposed to be a bass cut but I'd like to maybe modify it so I could actually hear a difference! Any idea?

Yes I did, but they don’t affect the signal clipping issue.

I also used these :

Hey everyone, finished building the Duo phase. Everything works perfectly except that there seems to be some clipping, or too much gain whenever I dig into the strings normaly. Is there anything I can do to curb this?

Recent build of Low Tide Modulator (Shallow Water clone). Using a J201 instead of the SK208-Y. Also a MN3207 instead of the VD3207D BB chip. When circuit is on, signal goes through without issues. But no effect is heard at all. When Mix is all the way up, no signal is heard. I played around...

Solved. Maybe some bad traces, but I ended up having to ghetto this thing like in the included picture. Using my mm for continuity solved the problem quickly.

Nope, I have it coming out of the Switch and it dies at R17.

Here’s the part of the schematic

You’re right, I swaped the mini board for a proper one. Signal enters boost circuit and dies right away. Doesn’t even reach C10.

Finisned putting this one together. OD side works perfectly, but boost not so much. When I turn it on and dime the boost knob, sound starts to stutter frantically. And it doesn’t boost, it just just muffles the sound. Also, with my audio probe, this is the weirdest thing I’ve seen : I clip my...

Pumbaa Distortion issues Hey gang, having weird issues with this pedalpcb Pumbaa Distortion, aka Thorpy Warthog. The volume knob and Calibre knob work as they should. But the Gain knob barely makes an audible difference, and there isn’t practically any gain audibly. And the tone does nothing at...

Do you think that it would cause the breaking up in the sound?

Bi phase distorts when digging in to strings This recent build of mine works perfectly except for the slight unpleasant distortion sound when i dig in a little on the strings. What could be causing this?

Its now fixed, it pulses correctly now. Except that I get a lot farting distortion if I dig in a little on the strings. Oh, and the spdt switch cuts the signal in one of its posistion. (I double checked, its a On-On)