PedalPCB Sproing Reverb/J. Rockett Audio Designs Boing Reverb 125b

OD is Glorious

Well-known member
Build Rating
5.00 star(s)
IMG_2136.jpeg

Decent reverb that sounds close to a fender amplifier spring reverb. It can add bounce and a natural sound. It really captures the sparkle and spring of a Fender amplifier. Just one knob so you do not get confused. Just like my only Fender amplifiers. If blindfolded I am not sure I could say which was the amp and which was the Sproing. This circuit will not get you Gravitation type endless echos and shimmers. This circuit sounds warm and classic... It can get you country twang, or surf-sounds.

Not a difficult build. I have built this circuit before and wanted a bit wetter signal and a more discernible Reverb sound so this time I deviated from the build with one resistor, I changed R8 from a 29k to a 22k. FYI: 10k is the value from the Sproing Deluxe but I chose a middle ground because it pleases my ears. This boosts the wet signal. Reducing R8 also gave me a better sweep - earlier reverb through the pot instead of most of the reverb at the end.

The onboard Belton Brick makes the magic here. I used the largest knob I have was a 45mm so I used it here. Oddly enough it is very smiliar to the original Boing's knob. I put dots on the face around the potentiometer like the original design but they were slightly off so I covered them with the big knob. I used an illuminated footswitch which is green like the 125b enclosure. The enclosure has a film free decal and a 2k glamour clear coat. I used Swtchcraft jacks and a soft click footswitch. I also -put some bougie WIMA caps in there.

Overall a decent circuit that delivers dripping wet reverb. Unity is great and cranking this circuit does not distort the dry signal.

Notes
  1. Consider changing R8 to a lower value. I chose 22k but the BOM calls for 39k
  2. You can also mod R9 by swapping out the 33k resistor for a 10k resistor (I prefer the R8 mod)
 

Attachments

  • IMG_2137.jpeg
    IMG_2137.jpeg
    281.1 KB · Views: 5
  • IMG_2138.jpeg
    IMG_2138.jpeg
    400.9 KB · Views: 3
  • IMG_2139.jpeg
    IMG_2139.jpeg
    342.5 KB · Views: 11
  • IMG_2135.jpeg
    IMG_2135.jpeg
    305.3 KB · Views: 11
Last edited:
Back
Top